基于电化学老化衰退模型的锂离子动力电池外特性

当前锂离子动力电池电化学模型存在模型复杂、建模难度大、计算效率低、老化评估效果差的问题,本文提出一种考虑电池衰退老化的机理模型(ADME).本文首先通过有限差分法对伪二维(P2D)电化学模型进行离散降阶处理,得到简化伪二维(SP2D)模型.在SP2D模型的基础上,基于阴阳两极发生的副反应导致的衰退老化现象,提出一种考虑电池衰退老化的机理模型.其次,使用多变量偏差补偿最小二乘法实现模型参数辨识.最后通过动力电池衰退老化性能循环实验,对比分析了恒流、脉冲工况下SP2D模型和ADME模型的终端电压输出.结果表明:ADME模型较为简单、计算效率和估算精度高,可以有效评估电池容量老化衰退,得到理想的锂离子动力电池外特性曲线.     

A rapid dissolution procedure to aid initial nuclear forensics investigations of chemically refractory compounds and particles prior to gamma spectrometry

A rapid and effective preparative procedure has been evaluated for the accurate determination of low-energy (40–200 keV) gamma-emitting radionuclides (²¹⁰Pb, ²³⁴Th, ²²⁶Ra, ²³⁵U) in uranium ores and uranium ore concentrates (UOCs) using high-resolution gamma ray spectrometry. The measurement of low-energy gamma photons is complicated in heterogeneous samples containing high-density mineral phases and in such situations activity concentrations will be underestimated. This is because attenuation corrections, calculated based on sample mean density, do not properly correct where dense grains are dispersed within a less dense matrix (analogous to a nugget effect). The current method overcomes these problems using a lithium tetraborate fusion that readily dissolves all components including high-density, self-attenuating minerals/compounds. This is the ideal method for dissolving complex, non-volatile components in soils, rocks, mineral concentrates, and other materials where density reduction is required. Lithium borate fusion avoids the need for theoretical efficiency corrections or measurement of matrix matched calibration standards. The resulting homogeneous quenched glass produced can be quickly dissolved in nitric acid producing low-density solutions that can be counted by gamma spectrometry. The effectiveness of the technique is demonstrated using uranium-bearing Certified Reference Materials and provides accurate activity concentration determinations compared to the underestimated activity concentrations derived from direct measurements of a bulk sample. The procedure offers an effective solution for initial nuclear forensic studies where complex refractory minerals or matrices exist. It is also significantly faster, safer and simpler than alternative approaches.     

EicC对撞光学设计

EicC是中国科学院近代物理研究所计划建造的中国电子-离子对撞机装置,该对撞机质心能位于20 GeV附近,是研究海夸克的最佳能量窗口,同时还可研究胶子和价夸克。EicC对撞粒子为高极化率质子和电子束团,质子环pRing采用八字环设计方案,可以更好地保持极化质子束团极化率,电子环eRing采用跑道形环设计方案,可以更好地利用隧道空间。该装置电子束流能量中心值为3.5 GeV,电子束RMS发射度为水平方向60 nm·rad,垂直方向60 nm·rad,对撞点b函数为水平方向0.4 m,垂直方向0.12 m;质子束流能量中心值20 GeV,质子束RMS发射度为水平方向300 nm·rad,垂直方向180 nm·rad,对撞点b函数为水平方向0.08 m,垂直方向0.04 m,设计亮度2×1033 cm–2s–1。EicC采用双对撞区非对称光学设计,通过对EicC不同色品补偿方案的研究,最终确定了弧区加短直线节共同补偿的色品补偿方案;通过研究对撞点处b函数以及对撞点间相移对动力学孔径的影响,最终得到pRing动力学孔径大于8 s(s为束团RMS尺寸)、eRing动力学孔径大于20 s,满足大于束团尺寸6 s的要求。     

基于色彩衰减补偿和Retinex的水下图像增强

针对水下图像存在的色偏、雾状模糊、低曝光和非均匀光照问题, 提出一种基于色彩衰减补偿和Retinex的水下图像增强算法. 首先, 为校正水下图像的色偏, 利用水体对不同波长光线衰减不一致的特性自适应地补偿其R、G、B通道. 然后, 使用基于多尺度导向滤波的Retinex去除雾状模糊, 增强对比度. 最后, 根据水下图像和自然图像的直方图分布特征对其进行归一化处理, 从而在保存图像主要信息的前提下增强其纹理和曝光. 实验结果表明, 该算法不但具有较优的视觉感知效果, 而且具有较高的图像质量评价分数. 该算法具有较强的适应性, 有助于计算机视觉算法在水下的应用.     

Widely linear equalization for IQ imbalance contaminated multicarrier systems

In a multicarrier modulated (MCM) wireless communication system, the received bandpass signal is downconverted to the baseband signal for ease of receive processing. During downconversion, a slight mismatch in the amplitude and phase of locally generated sinusoidal signal in the In-Phase and Quadrature (IQ) branches of downconverter results in IQ imbalance of the baseband signal. The IQ imbalance leads to mirror interference between subcarriers of an MCM system and degrades the performance. To compensate for the effects of IQ imbalance, this paper presents widely linear minimum mean square error (WL-MMSE) based equalization technique and compares it with the traditionally used linear minimum mean square error (L-MMSE) based equalization technique. A performance comparison between WL-MMSE and L-MMSE based estimation techniques in terms of mean square error (MSE) and bit error rate (BER) suggests that the former outperforms the latter in the presence of IQ imbalance.     

Error evaluation for Zernike polynomials fitting based phase compensation of digital holographic microscopy

Combining the experimental research with the simulation calculation, the error evaluation for Zernike polynomials fitting (ZPF) based phase compensation of digital holographic microscopy (DHM) is performed. The obtained results show that the reconstructed phase with high precision can be obtained by ZPF phase compensation algorithm. Moreover, the phase error for ZPF based phase compensation algorithm increases with both the variation of object height and object transverse area, the larger variation of object height, the larger of phase error, and the larger of object transverse area, the faster increase of RMS phase error. To decrease the error of ZPF phase compensation algorithm, it is required to ensure one of the variations of object height and object transverse area to be a small value. Importantly, the proposed method supplies a useful tool for the error evaluation of phase compensation algorithm.     

沿海石化基地对地方生态环境补偿的科学基础与系统框架

生态文明建设既需要产业自身绿色发展,又需要利益调节,实现规模性达标排放行业与地方和谐.沿海石化基地既是中国能源与化学工业的集聚地,更是各类规模性达标三废集中排放区域,为此生态文明的地方实践要务就是推进石化基地对地方生态环境补偿.因此系统分析指导中国石化集聚区对地方生态补偿的外部性、公共物品、可持续发展、绿色GDP、博弈论等理论,构建宏观层次的生态环境补偿原则与补偿程序、中观层次的利益主体参与式的补偿运行机制,以及微观层次企业、居民、多层政府协商的生态环境补偿完善机制,并总结国内外实践经验,可以为地方践行生态文明理念、创新生态发展模式提供理论指导.     

Remarks on Neumann boundary problems involving Jacobians

In this note, we explore the validity of Wente-type estimates for Neumann boundary problems involving Jacobians. We show in particular that such estimates do not in general hold under the same hypotheses on the data for Dirichlet boundary problems.     

聚变堆遥操作上层协同控制系统设计和测试

为了解决聚变堆遥操作维护上层控制系统普遍存在的软件功能模块过于集中、拓展性差、不具备中层运动规划能力等问题,设计了一种基于机器人操作系统(ROS)的上层协同控制系统。该系统采用分布式架构,基于市场成熟的开发平台进行设计,集成了中层运动规划与动力学虚拟仿真功能。通过“轴销抓取”的实验场景测试的结果表明：该系统满足设计需求,运行稳定。     

Effects of ball-to-powder diameter ratio and powder particle shape on EDEM simulation in a planetary ball mill

The effects of the ball-to-powder diameter ratio (BPDR) and the shape of the powder particles on EDEM simulation results and time in the planetary ball mill was investigated. BPDR was varied from 1 to 40/3 by changing the powder particle diameter from 8 to 0.6 ?mm. The size and shape of the powder particles do not give a significant change in both the ball motion pattern and simulation results when BPDR is over 20/3. It can be assumed that the kinetic energy of the ball has nothing to do with the size and shape of the powder particle. The simulation time and data size increase exponentially as BPDR increases. The effect of change of the powder particle shape on the calculated data size is not significant, but the more complicated its shape, the longer the simulation time, which is linearly related to the number of spheres composing a particle.